Actually see an artifact is not only a strength of Shanghai numerical control lathe processing factory, also can see it for some detail treatment method, for numerical control lathe processing parts, if Shanghai numerical control lathe processing factory processing is not good, then this job is not can use, so when the numerical control lathe processing for manufacturers, What to watch out for?

A, the price of the surface of the burr, it can be said that for this point is a lot of manufacturers are easy to ignore, a lot of people say that this part is what kind of time, the finished product packaging is what kind of time. In fact, for a part, CNC lathe workpiece is completed by equipment, so when injection molding will produce cape, and this burr is also produced at this time, if not timely pruning, or the part is invalid. Otherwise, it will also affect other links when it is used.

Second, the accuracy of parts, for numerical control lathe processing parts, its accuracy is very strict, only meet the requirements of accuracy, can be used, and judge the accuracy, it basically is to see him for the size of the control ability, if within the provisions of the tolerance can be volatile, so this part is qualified, if out of tolerance, it is not qualified.

Three, the analysis of the test results for a component, it before leaving the factory, will inevitably pass some kind of performance test, if the performance is good, then it will be to the factory, if it is not qualified, you should analyze some of the reasons, this also can avoid large quantities of scrap, numerical control lathe processing industry in Shanghai factory would basically to deal with, They will make a certain quality control chart according to the performance of many homes, so as to analyze the reasons.

The process requirements of typical parts are mainly the structural dimensions, processing range and precision requirements of parts. According to the accuracy requirement, that is, the size of the workpiece precision, position precision and surface roughness requirements to select the control precision of the numerical control lathe, choose according to reliability, reliability is the guarantee of improving product quality and production efficiency, the reliability of nc machine tool is refers to the machine to perform its function under prescribed conditions, run stably for a long time without fail. That is, the average time without failure is long. Even if a fault occurs, it can be recovered in a short time and put into use again. Choose reasonable structure, excellent manufacturing, and has been mass production of machine tools, generally, the more users, the higher the reliability of numerical control system.