When it is determined that there is a problem with the machining center coding program, the machining center operation and technical personnel should first adjust the fixed components in the comprehensive inspection of the equipment, so as to summarize in many ways to locate and find the problem in time.

In the process of checking the problem, the power supply of the machining center should be restarted first to ensure that the equipment can operate normally, and the electrical components associated with the equipment and spindle should be further examined to determine whether the parameters in the running parts need to be changed.

After determining the cause of the fault, reconnect the replaced wire and find the cause of the fault by carefully checking the positioning Angle of the spindle. Normal processing center manufacturers will install the photoelectric encoder at the bottom of the spindle box in accordance with the design standards of the NATIONAL standard. If the seal is not good, the lubricating oil will overflow. In this case, professional and technical personnel will clean the oil carefully, and the problem can be solved.